Remotes, the wall keypad, the button by the kitchen door and the app on your phone all need to agree with the opener. For homeowners in Byng we program them cleanly, erase codes from remotes that went missing years ago, and show you how to add a new one yourself when the time comes. We also come out to Attercliffe Station, Lowbanks, Moulton Station, Mount Carmel, Oswego Park, Port Maitland, Stromness and Attercliffe.
Garage door services
Whatever brought you to this page from Byng, a door that stopped, a noise that started or a plan for a new door, the services below explain what we do about it. Repairs and maintenance, springs and hardware, openers and remotes, and new door installation are each covered in detail.
Byng
Garage Door Safety InspectionIt has been a hard winter.
Garage Door Tune-UpSince the first cold snap the door has been sluggish.
Off-Track Garage Door ResetThe morning after a thaw the opener groaned, the door stayed stuck to the icy floor for a second, then lurched up crooked.
Garage Door Hinge ReplacementWatching from inside as the door opens, you can see the gap between the second and third panels open up on one side as they turn…
Garage Door Cable ReplacementSomeone left the snow shovel leaning in the opening and the door came down on it.
Garage Door Opener Diagnosis and RepairYou press the remote from the driveway and hear the motor hum overhead, a steady drone with no movement behind it.
Chain-Drive Opener RepairThe door closes, touches the floor, then climbs straight back up as if it hit something.
Photo-Eye Sensor Alignment or ReplacementThe small light on one of the sensors near the floor has gone dark, or it flickers when someone walks past the track.
Smart Garage Controller SetupThe house came with a controller already screwed to the garage ceiling and a sensor on the door, but the app insists the device…
High-Lift Garage Door ConversionA taller van clears the closed opening comfortably, then loses useful space when the door is raised because the bottom section…Repairs
Sealing out the weather is part of repair, not an afterthought. Along with the mechanical work, we replace bottom rubber, perimeter weatherstrip and worn thresholds so the garage stays drier and warmer.
Springs
A spring can look fine and still be finished. Coils that have lost their gap, rust pitting along the wire and a door that needs a shove to start moving are all signs.
Byng
Our technicians in Byng carry the winding bars, clamps, stands and gauges the work needs and use them every time, on every door. Spring sizes are measured, not guessed; cable lengths are matched to the drums; opener force is set with the door balanced. The result is a door that behaves.
— Caledonia Door & Opener Co.
Hours
Haldimand-Norfolk, Ontario
2021 census · what it means at the door
57%Older homes
About 57% of homes in Haldimand County were built in 1980 or earlier, according to the 2021 Census.
In a mature neighbourhood the garage door is often the single largest feature of the front elevation, so keeping the original look matters. Modern insulated doors come in raised-panel and carriage styles that echo the older designs while running on today's torsion hardware.
84%Mostly houses
Single-detached houses make up about 84% of homes in Haldimand County (2021 Census).
Detached homes usually have their own driveway and apron, and years of freeze and thaw can leave the concrete uneven where the door meets it. A thicker bottom seal or a threshold strip closes the gap, keeping snow, leaves and cold air out of the garage.
Byng
Garage Door Safety Inspection
It has been a hard winter. The bottom seal froze to the slab twice, the opener groaned each morning, and one afternoon you noticed a cable on the left side hanging with a little slack in it.
Garage Door Safety InspectionIt is a look and a record first. Small maintenance items such as lubrication, cleaning and aligning the photo eyes and tightening fasteners can be done on the spot if you wish. Anything involving spring tension, cables, drums, worn rollers or damaged sections is written up with a clear explanation and quoted as its own job, so you decide with the full picture in front of you.
For a single or double residential door with an opener, allow roughly an hour to two hours on site. The inspection and the two observed cycles take a fixed amount of time; the rest depends on how many fasteners have loosened, whether the sensors need realigning and whether you approve a small part replacement, such as a worn roller, during the same visit. Spring or cable work, if found necessary, is scheduled as its own job.
A door that sits tilted almost always has a lifting cable that has gone slack, unwound from its drum or broken on the low side. The springs are still pulling on the other side, which is why the door racks and the rollers escape. Leave it where it is; levelling it means handling the springs and rewinding both cables evenly, which is done with the door clamped and the tension controlled.
Whether the door is closed, open or stuck; where the noise or the gap appears and roughly how high; whether you can see a cracked, bent or loose hinge and whether it is at the edge or the middle; whether the door is a single or a double, steel or wood, and how many panels it has; and whether anything hit the door lately. A photo of the hinge and its stamped number is useful.
Whether the door is sitting crooked, jammed partway or on the floor; whether you can see a cable hanging loose, frayed or wrapped around the shaft; whether there is a spring above the door or springs along the tracks; the door's rough height and whether it is a single or double; and what happened just before, such as the door coming down on something. A photo of the drum end and the bottom corner is useful.
On-site assessment preferred
Send a few details about your door. Tell us what happened.
Open 24/7 · same fees any hour
On-site assessment preferred · (365) 651-2018 · open 24/7
